Recent content by leverhead

Good pic...thanks for sharing....they should all be welded IMHO. Ordered lift from summit a few weeks ago but build date on the data plate says 8/18 ....

I called bendpak and they said it is a strap for the underside of the offside ramp. The holes don't line up very well so I couldn't use the supplied hex head cap screws anyway....I used std hex but slightly smaller diameter grade 5 hardware (pic included) and mounted the strap inside (on top of...

They do now.... There is about 1/8" + difference between the bottom of the runways and the bottom of the crosstubes....iow, the runways sit slightly higher 'off' the tubes....so.... thinking if I mount them INSIDE the bottom rails and get some grade 5 bolts and grind the heads down to 1/8" +...

No....there is an identical ******** the power side but it is welded on....underneath the power cylinder. The holes on the offside match up perfectly with the holes in the strap so I assume that is what it is for. However I don't see how the runway can drop flat on the floor and be even with the...

Hello all. Long time lurker....first time poster. Just finished 'raising' a new HD9XW. Went well, other than the mediocre instructions. I noticed one leftover part that seems to be a runway strap that gets installed under the offside runway with cap screws and washers/nuts (pics attached)...