Recent content by lilrob1213

I searched 1 and it came up with a ton of Penny items

Okay... I wanted to update this thread and say thank you all for your input. I tried out that roto head 3/8 drive ratchet with long t-handle from harbor frieght, but even with grinding my socket, still couldn't accomplish the job. I finally broke down and bought a snap on 3/8 drive in 1/4 body...

I do, however, the housing sticks out at an awkward spot and I think there's not enough clearance for the ratcheting wrench.

Okay, here's what I'm working on. It's a picture of an Air Tractor (crop duster). The space is really tight. It's two bolts facing aft holding the A/C housing to the drive shaft housing assembly. I should have measured the space between the end of the one bolt and the head of the other, but I...

Thanks! I think I might stop by harbor freight and check this out tonight!

Hi, could you please measure your 3/8" drive gearwrench roto head ratchet? I would like the dimensions from the edge of the square drive side (not the end but where the socket would **** up against when seated) to the back end of the ratchet where the selector is? If you could include...

I can't seem to find this t-handle ratchet. Could I get a part number or link? Thanks!

Wow this thread is blowing up! I expected like two replies but you guys are awesome! One of y'all hit it on the head. The Snapon ratchet I have found that works is the FHCNF72. Its a 3/8 drive in a 1/4 body. And I have to use a 17mm socket and the only one I have thin profile enough is 3/8...

I've been looking for a cheaper version of the snap on 3/8" swivel head ratchet. It's the only ratchet I've found that works in a very tight spot on a certain job and only with a certain socket... that's how tight the spot is. Now, I've been searching for hours trying to find a thin profile...