Recent content by LIMagna

The red and gray combo does go very nicely together, doesn't it.

Thanks! Yes, it's RaceDeck diamond.

Thanks Jorgen! Feel free to use the photos as you see fit. Jennifer gladly included a pair of the jack pads I had seen mentioned on the forum to help prevent the kickstands on our two bikes from marring the floor and I have to say I'm very impressed with them. I'll probably call to order a...

And Here It Is! Just thought I'd tack this onto the end of the thread I started ... This past weekend I had an opportunity to get most of the RaceDeck installed in my garage. Because of a little mishap with UPS, some tiles were damaged in transit (they apparently dropped a box on its corner...

Just placed my order for RaceDeck with Jenn. Can't wait to get working on the installation :) Thanks to all for the help and especially to RaceDeck1 for treating Garage Journal members so well (even us newbies).

Thanks, I understand your point (hadn't considered that at all) but I'm not sure the extreme corners will matter that much. Nothing will be standing there so to just lay the tile in place would be good enough. In fact, I can probably use a scrap piece to make a custom corner for the upper left...

I think I have my answer ... I do appreciate the feedback and advice but the diagram I've attached illustrates what I meant with my original question. The piece on the left was cut from the right side of a full tile (same orientation as the full tile in the diagram) and would be used to fill...

The ramp edge is 3" and yes, I'll be putting that across the entire front. I've taken that into account I think. I'm all for having some extra tiles and wouldn't hesitate to purchase more than I need if this was my local Home Depot but since shipping the tiles back would probably cost more...

I understand the requirement for male-female connections but as you point out, there are two sides of each so technically, you could turn that very last row (the small slice I cut) and everything should work properly as the adjoining tile section (the next piece you cut) will also face the same...

Hello everyone. My name is Charlie and I'm new here. I've been gathering information for a garage floor makeover and ran across GarageJournal. I've already gotten most of my questions answered by the fine folks here and have even reached out to RaceDeck1 for assistance. I'm torn between...