littleboss's latest activity

I am afraid of Hercules, Ryobi and similar brands. I am not a full time mechanic but a retired farmer but I use my tools everyday. I...

Spray foam all the way (I'm in TX). Don't do the "attic" thing - cost is and time to build is going to eat you. Just pull that RV out...

It does not look to me like you are removing much volume or reducing the wall area much by lowering ceiling. Spray foam. The only...

Hard to figure how long it would take to pay for the ceiling and supports in the utility bills.

It will be a lot easier (and cheaper) to control the temperatures with the drop ceiling (from experience/commercial contractor).

Currently the barn has triple doors on each end so I could load and unload hay from either end. Those will be removed and I will have...

Still planning on converting my 37x 63 hay barn into a shop. My plan is too make one section (18' wide x 37') have a 14' walls for a...

Would be handy to carry in the gooseneck equipment trailer as well.

A 4 CFM compressor will run that jack just fine, especially if speed isn't a priority. The jack only uses air in short bursts to pump...

I tried it on my 32' gooseneck trailer. 12 ton HF jack and Bostich pancake compressor. I did have to let it fully charge first but...

Anybody know if a HF 12 ton air/hyd jack will run off a 4cfm air compressor? Thinking about carrying this compressor and the 12 ton jack...

I would think you would be much better off with an ultrasonic cleaner especially for carbs.

Looking for a parts washer that I can use solvent in- not water based. Not gonna use it very often- mainly bearings and carbs so I...