Recent content by llaht

you've a challenge, those CNC machines will give off heat, and the coolant used for machining will mist off raising humidity. not so sure you have 'enough' but certainly insulation is your friend.

2001 dodge Ram 3500, a/c reduced cooling and short cycling... had been like 2017 since last fill..... and it sits a lot. decided instead of just topping it off back in April, took it to shop that did last work. when he removed the cap for suction side he said... " probably a bad valve"...

recent gree minisplit on garage, had an option on line covers, or not. I felt it best for longevity for the line set insulation to shield from the UV rays of the sun... the line covers not really cheep, but they looked fine. I will be taking some bronze wool to the open end near the...

no, does not appear serviceable, plastic 'spot welds'. i need a better pic, but the black colored component in the top left of the image behind the red trigger seems to be the 'key' I "think" it originally was spring loaded with an outward longitudinal force against the trigger when the...

89 views and zip... guess 'really' obsolete on the switch...

have a 'vintage' craftsman saber saw... model # 315.17270. no workee, have traced to the switch, variable speed i "thinK" the switch is spring loaded internally and the sliding switch no longer slides with the trigger movement. if i try to run with the switch removed, and locked in full...

Box mentioned in post 4, couple of stickers probably stuck on there in the early 1980's drop front cover, think a total of 7 drawers, i may go back over to shed and count ..... inside, not all Bonney tools, there a big mix, Some snap on, Bonney, J. Williams, old craftsman, and of course...

Have one here i believe, was gifted to my father around 1970 from folks he procured machinery from, it was full at that time, have not looked at it in a while...

had similar occurrence with a HF dead blow hammer opened toolbox drawer after being closed for years and all left was the internal metal core of the hammer. the outer was 'dust'.... have seen same with some casters ... that chinese plastic....

Is that not a "G" , seems to be the beginning of a signature in an arc...

Thank you, signed in and can see the forum now... was unaware of the restriction.

see title.

Fitting up some OLD stuff is really a challenge. have an old water filter, get a few years before the O-ring compresses and will not seal. think it is OMNI brand. Local hardware has display of Buna N... IF i get a 3 5/8 ID, i can't get it to 'seat' freely so it will stay in the groove while i...