Recent content by Lobzik

About this engine a lot of information.

There is no sense to do a press more than 20 ton.60 tons effort it will be hardly necessary for a workshop. And as, for effort more than 20 tons, it will be necessary to do very powerful basis!

I'm doing a bending machine itself. http://www.chipmaker.ru/topic/100666/page__p__1583342__hl__äåëàþ%20òðóáîãèá__fromsearch__1#entry1583342

I did the press so.

This car was in different presentations. Competitions on auto sound,car sound,DbDrag. Went by it in automobile races to Poland, the city of Varshava, in Krym,the city of Sevastopol.

The first car which, I have restored, it ZAZ-965. Release of 1967."Zaporojec".

Manufacture electrotools in Russia and China. The sizes at us specify not in inches. All the sizes long in centimeters and millimeters. It is not seldom used old keys.

At us in a network 1 phase 220 volt or 3 phases of 380 volt. In this garage of 220 volt. 2NASTYZEN Yes, I use such transformer for welding by an alternating current, 150 amperes. And networks not always 220 volt. I use a voltage stabilizer.

They are squanderers from car UAZ.Frame from Willys 1943.Gas-67b while costs in other garage in turn. It is other project.

:)

Tools as which I work. These I work as the device more than 15 years

These are our places!:) I worked in Chernobyl as the welder in 1992-93. In Pripyat watched film at a cinema, ate in a dining room.

Outside the Vinyl siding,inside pvc wall panel.Сeiling pvc panel.

Спасибо,Ротор!Очень приятно услышать теплые слова от земляка.:beer: Thanks, Rotor! It is very pleasant to hear warm words from the fellow countryman.

Thanks! New York 2009.