Recent content by ltlvt

lunacy this is another of my very favorite LED lights. It has a magnetic back and as you can see I have it attached to a Chevy push rod. This gives me any angle I need on the light. I have the pushrod in a magnetic holder on the side of my milling machine. I bought this off of Ebay from a fellow...

I will never go back to fluorescent. I have replaced or converted all of my 4 ft to LED and intend to do the same with my 8 ft. I convert them to use LED with no ballast. I also have a kit to convert 8' to use the 4' bulbs. The sky is the limit when it comes to portability. Thanks for your...

It is the motor vent cover for the Clausing 5913 lathe.

I already had the fence stretcher and the hoist on the trolley. The light is a 4 ft LED from Sam's. I am currently in the process of rebuilding the Clausing 5913 lathe for my shop. Thanks to some really good advice from newly found friend OccupantRJ his recommendation of the carbide scraper...

I am always in need of a way to clamp things down to a table top to work on. I used the concept of Tee slots and Tee nuts that would be used on a mill table except I used the Harbor Freight Clamp and made the table top out of wooden slats I made from some very old shipping crates I salvaged 30...

I have been a member for a while but when I tried to post a private message I was told that I must have made 3 post before I can use the messenger option. So I am here to pay my dues. This is what I call my Toolbox mill stand. I bought the PM 833-T mill new and also bough their factory mill...