Recent content by Lucas21

Oops, Here is the spec sheet for the urathane:

I attached a pic of the specs for the product. It is a urethane, 70% solids I think. I just applied way too thick as you said. I applied it in a similar fashion as I did the epoxy which is wrong. Yeah i wasted a lot of product and now will need more to even it out if I want to. Is the mal-grit...

I just called PPG tech support. They said you have up to two week to apply the product over existing top coat without sanding. However, he did say to sand and make it even then since I have a lot of product on there already, I can just go over it again and thin it down 15% to go further and give...

Ha, I need to fix this pic. My fault, first time posting:-)

You think it looks good and I'm just being a perfectionist here?

Thanks for the follow up! I used 1/4" nap roller designed for poly and adhesives it said. Then I switched to a 3/8" for a second coat to try to make it better. unfortunately it just made some spots higher instead of leveling it out. It's been 5 days since I applied the poly. I guess spraying...

Just finished my epoxy floor. It was a ton of work and I loved how the epoxy turned out. But, when it came time for the poly top coat I struggled with this product in getting it to even out. It was really hard to see where you last rolled and so some spots got too much and some not as much. That...