m.d.hunter63@hotmail.'s latest activity

i have used both blackjack and safety seal, same kit really but blackjack has nicer tools over all. i use xtraseal brand plugs, they...

Ok, can we drop the yay/nay tire plug debate? OP want to use it in his vehicle for emergencies; he's not running a business. I've had...

A quality benchtop mill is like finding a quality 4x6 band saw, pretty rare. There's a reason that Bridgeports are so popular; they were...

Ummm.... nope, how would one even do that? Just did some quick measurements, 3.5 inch cast iron table, 1/2 inch air gap and 3/4 inch...

Have 4 mills, zero drill presses, I'm an amateur

Seems they only have one plant, so that's it for them as a proper toolmaker?

I have several Reeds, not sure where you get "low quality" from? My 6 inch Reed is stouter than my 6 inch Wilton bullet vise.

Sub $100 thats a pretty tall order you didn't specify what torque range in/lbs ft/lbs. Look at Tekton, they have lifetime warranty and...

The mesh bag is called a mantle. When you first install it, it is too big and very flexible. If you light the mantle on fire, which...

I like to use them for LPS 2, WD40, kerosene and naptha

Looking for an oil resistant spray bottle, WD-40 used to sell one, but they have stopped. Any recommendations?

The standard to whom, and where is an important question. In the US, in a professional place of work the SO truck is or can be your...

Just curious, how did Snap On become the standard that all others are compared to? Was it cost? I have Snap On, Proto, Mac tools. I...

How much run out do you have? Drill chucks are not precision tools.

Put lapping compound on the chuck taper, then insert and remove a couple dozen times. Then thoroughly clean compound from the chuck and...