Machinehead's latest activity

Great job! Can I ask a few questions? Can you show how or what you used for the rivets? Also anymore on the painting, that looks like a...

Well well well you are so right, it shows 4 days!

That looks 3D printed with a Matco logo. I bet someone makes one on Etsy like it or close enough.

I don't know where id ever get sardine cans, or get the smell out, but that's a good idea.

Not the greatest but I think its the same as last year, maybe not. If you don't have anything large to buy it kind of disappoints. But...

Recently finished this Park 7-drawer machinist tool box. Haven’t found a door yet. Very similar to the Kennedy 520 but found out the...

All sealed that I've seen.

I may check out the Norseman but a lot of things go misplaced around here and I don't have to pay for it really. But I don't think I...

I'm looking for a set to just make blind holes and drill out softer material. Not them 200 or 300 sets. I mean if I lose the set or its...

It says they are not 100 plus. There are some really old models out there even being made in the 30's. Ive seen really old Stanley...

When you look up pliers on their site it shows you the 7in strippers.

I did too to fill all the missing ones I had, but for some reason the 7in wire stripper from Icon was not discounted and I went back in...

Hello all...I was looking for a Wilton bullet vise for a long time but couldn't bring myself to buy one on the 'Bay with the prices...

replaced mine with Omniwall

You had to buy 4 sets to get 40%, it would of been better to have 35% on any Icon set. And it seemed that way because all 4 stores near...