Recent content by magimerlin

  1. M

    How to move this rock Update: Rock Moved

    Re: How to move this rock Sooo. What's your question? You have access to a tractor so use the bucket and roll that big boy to its new spot... sent from what use to be a great country...
  2. M

    How to heat a detached 20x10 garage

    Cinder block structures are a pain in the *** to keep warm... depending on the size of the garage.. you will have to insulate it.. which in your case you will need to build walls then insulate them or... use foam insulation board/panels to help to.. and do not forget the ceiling/roof. Be...
  3. M

    How to heat a detached 20x10 garage

    OK gotta ask..... what are we talking about for tires here...radial tires are made to take extreme temps up or down... yes the air pressure will fluctuate with extreme air temp changes but will not adversely effect the actual tires rubber..... Soooooo.. what type of tires we talking bout...
  4. M

    HF 44 toolbox question

    Yes you can... sent from what use to be a great country...
  5. M

    How much play/wobble are in Harbor Freight "red" tool cabinets?

    If I remember right.... I think is was this group... there is a whole thread dedicated basically to the HF boxes... sent from what use to be a great country...
  6. M

    How much play/wobble are in Harbor Freight "red" tool cabinets?

    Re: How much play/wobble are in Harbor Freight "red" tool cabinets? I love my HF 44"... only wish, like most, it was deeper.... I am a full time mechanic. I use the 44" box plus the matching top and the matching side box.... Since it was mentioned above.... No its not a snap-on...
  7. M

    Hey from Texas

    Welcome from westpoint... sent from what use to be a great country...
  8. M

    Rolling/Sliding Jacks?

    LOL..... sent from what use to be a great country...
  9. M

    Rolling/Sliding Jacks?

    No arguing here... that's just my preference.. reread my post carefully that you replied too... I'm agreeing about a 4 post... I have NEVER once wanted a 2 post instead of my 4 post I use at work... I do everything from oil changes to transmissions to engine swaps to brakes to ball joints...
  10. M

    Rolling/Sliding Jacks?

    I'm on the other fence here... I have never once at work wished I had a 2 post instead of my 4 post to do any of the work I have done... and I'm a full time mechanic.... sent from what use to be a great country...
  11. M

    ir2131 impact wrench rebuild gone bad

    Did you remove the cylinder also... if so it has a hole that has to line up with one side or the other... it can not be in the middle..... sent from what use to be a great country...
  12. M

    oil change with lift catching the oil

    We use these at work. One set for trans and motor oil changes.. and a second matching set up for coolant flushes or any job that requires coolant to be drained.. sent from what use to be a great country...
  13. M

    Rolling/Sliding Jacks?

    It has lifted everything I have asked it to so far.. right up to a fully stocked ambulances... sent from what use to be a great country...
  14. M

    Rolling/Sliding Jacks?

    We use at work "Worthy lifts. My Bay has the alignment style 4 post with 2 air jacks (2 air bags per slider) that I use on a daily basis. Easier to do tires that way and frond end work I use them alot to support the front so I can take both tires off.. it's a 12000k lift set up.. we have the...
  15. M

    finish carpentry question..

    Home depot and Lowe's both will rip the board for you. First cut is free at both locations if I remember right... sent from what use to be a great country...
Top Bottom