Recent content by maintguy

It is nice and refreshing to hear somebody. Wanting to help another person out. Go for it.

10 miles a day. What do u do there?

Very common in Industrial maintenance

I have both. I like the Irwin's better. I consider myself a huge channel lock fan. I still prefer the Irwin's

Milwaukee or Lennox. The Irwin branded ones aren't too bad. Stay very very far a way from the Menard's house brand blades. They just plain ****

fluke t6

try this https://www.lowes.com/pd/AWP-HP-Polyester-Tool-Bag/1000330347

you thinking something like this?

square to round fitting several ways to do this

The last factory I was maintenance at,only had a stick welder. It freaking sucked. It wasn't mobile either. Had to take everything a part and take it to the shop to weld.

Hell even in industrial maintenance. I hardly use my 2 pairs. When I was doing a lot of plumbing. I would mainly use them for basket strainers. My 20 inch pair was only used a few times on a steam boiler job

Milwaukee use to be make a good blade. Haven't used one in years. I hope they area still good

They actually have some of the better deals compared to most stores.

X2 I really like their pants. For the price they can't be beat

120 volts. In an a,b,c ( 3 phase system) please explain Also a member. Will tale you If. There is a problem on the circuit Why are these breakers being replaced and not reset?