Recent content by Mark71GTX

Do You think that pump would live through kerosene? I have a dead pump on my washer and don't want to spend $80 on a good pump since I do not use it often.

Keep an eye on Craigslist for used trailers and talk to people at work about trailers. Some people have trailers they do not want or need anymore that you can get cheap, or even trade for. Also, I am a welder - I was given one of those CH welding machines and I was amazed at how big a POS it...

Possibly, but I have another ratchet that is built in a similar way with what looked like the same ring, but it had too wide of a spread and did not fit. I figured it can't be "that" special, but I have not found anything just like it yet. I figured someone has ran into this before and can...

There is no number on the handle. "V" is the only marking on the handle. I have considered buying another one just to get the clip, but if i can get a clip, why ruin another ratchet?

There is one on eBay right now just like it. I don't know how to post a link to it from my phone, but it is listed as vintage craftsman early v series ratchet with oil port 1/2drive usa Sent from my XT907 using Tapatalk

I have this old ratchet my grandfather had on the farm. I used it for many years, but a while back it froze up. I took it apart, but one of the feet on the retaining ring broke when I took it apart. I had to pull it apart by distorting the rest of the ring pulling it out from one side...

I found this site searching for a repair kit for an old ratchet. I have been trying to get all of my tools sorted out and I pulled this one out. It looks too good to junk it so I pulled it apart and greased it up some. The only problem is it does not hold in the "on" or "off" position unless...