Recent content by Markmanuel

I have been following this thread for years and have to say I have seen some very inspiring mods throughout the years. JavyLSU’s white cart is absolutely stunning in a more recent post. I have done a few mild mods over the years but after laying down my racedeck floor, my old black cart needed...

Gluing transition piece was my exact thought when reading through this thread. I just finished installing racedeck on my floor. I used the 12”x12” for this very reason. The only option in my opinion is gluing transition to a cut tile at the garage door.

I had a mid sized SUV, a Corvette and my Harley parked inside. My vette had to park slightly diagonal to fit it in and provide enough room to avoid door dings. Actually selling my vette is what inspired me to redo the garage now that I have tons of room. My full size truck parks on the driveway...

Based on your location, free flow is the correct choice. I like the pattern and using 4 tiles in each checker board is the way to go. You could even go 6 tile checker board with your large area. I think your man cave area can get away with single like you have it since it’s smaller. I just did...

Amazing how similar our garages look. I’m not sure if my pictures show it, but my compressor is located in the same area between garage doors. I raised mine on a platform with a wired on off switch lower. Prior to ordering I was skeptical to go blue and alloy as I couldn’t find many example...

Your sig “Remember speed kills.......own a ford and live forever” is hilarious.…. And I own both a Ford and a Chevy

After a lot of research I decided on going with Racedeck flooring in my 3 car garage. The quality and thickness was a perfect combination for me. I also like the fact that I could work certain areas of my garage at a time, and have cabinets and other items on the other side unlike epoxy floors...

I also ordered 600 sq ft and some change and their discount with free shipping was Cheaper than anywhere else I could find. Stay tuned for an install thread coming later tonight.

I bought all from Amazon metric= http://www.amazon.com/dp/B002S0O9MK/?tag=atomicindus08-20 standard= http://www.amazon.com/dp/B002S0O9LQ/?tag=atomicindus08-20 torx= http://www.amazon.com/dp/B002S0O8BM/?tag=atomicindus08-20

Much appreciated

I agree with you... My channel locks are my go tool tool for that type of work. Funny thing is when I was organizing the drawer last night I couldn't find my large channel locks. I ended up putting the 2 robot grips in the drawer instead. As luck would have it I found the large Chanel locks this...

That is hella funny!! I don't have the rubber ends your speaking of. I wonder if anyone else has these lol.

Thanks so much... I cracked up reading your signature!!

Thanks!! Inside dimensions of each drawer is 32-3/4" wide by 21-1/2" deep.

Full set of Wiha hex in standard and metric and a torx set. I just put them in my just finished home made tool cabinet. [/url][/IMG]