Recent content by maruscmn

Another high recommendation for Ash and his business! I just ordered some NWS pliers and a level from him on Saturday and on Sunday he already was shipping them out. Phenomenal communication and super fast shipping. I foresee my funds going to his business. Mike

That thing was a dirty slob last time I saw it!! Hell of a job.

Great thread!

Thanks! As you can see from the pics it is a family man's cave. It started as a "John Deere" room which I converted to a 3rd garage. M

The i had the three back holes at 3.5 inches deep. One of them did not seat until 1/8 above the concrete. The other two (at 3.5) held great. I am thinking of doing the same thing and putting an epoxy anchor in but am unsure. I plan on keeping my posts up 99% of the time. I am also looking...

Finished installing the lift. I only had one problem with one bolt which i had to use epoxy on. The concrete was 3.5 deep near the wall and 5.5 in the middle. Love the product so far!

It will be a while before i run mine also but i will post results here.

I talked to Dannmar this morning re: the long hose. They said to put the fittings at 45 degrees to create more of an arc for the hose. If it leaks they said to call back. I will try it out tonight.

Thanks for the adivice! I think an inch could be done with a bend in it.

I just went downstairs and tried it again with no luck. Close but no cigar in my case. I will contact Dannmar tomorrow to see if they have a solution. Thank you for the time though and best of luck with that cement! Mike

See attached pics (hopefully) Mike

I will post pics as mine currently sits. If the power supply sat as it does in the dannmar pic (reservoir sits on the bottom plate) I think the hose would work. That would require drilling 4 new mounting holes though.

Could someone from the group buy please post a picture of the left side of the power unit on the cart? The first indication something was wrong was when the backing to the cart was installed upside down from the factory. I also only have one long 90 degree npt fitting. The second one that came...

Just ordered! Thanks Skamp! ps my wife hates you.

2200-2300 ish. This is a great deal!