Recent content by Matta986

Thanks

Anybody know if it is possible to put two of the 7 drawer end cabinets on the HF 44" tool chest? Instead of one 7 drawer cabinet and one that is full height with the large door. Thanks

Ok, thanks. That mod looks pretty interesting.

Does anybody know if there is a front and back to these lifts? Or does it not matter which way a vehicle is put on the lift?

I hear ya. That's why I'm asking if the kwik bay actually gives you more access.

Anybody?

So I'm trying to decide which scissor lift to get. I'm stuck between the Atlas kwik bay and the bp MD-6xp. The main advantage to the Atlas lift is the open middle, but, is there really an advantage? Is there enough room between the cross members to do work there? Such as ****** work...

Excellent. That's what i figured but just wanted to be sure. Thanks a lot everybody.

Do i need to worry about derating the circuits because there will be so many wires in the conduit?

it will be a 30 amp circuit.

When determining the correct wire gauge it will basically be a 100 ft run correct? 50 feet from the shed to the garage then 50 feet back to the shed.

Great. Thanks for the reply. Can i put it in the same conduit as the sub panel is fed from?

Been a long time lurker. Lots of good information on this site. Have a couple questions So I’m building a storage shed and I plan to put a 40amp sub panel in it fed from the 100amp sub panel in my garage with 8 awg thwn wire run underground. Shed is about 50 feet away. I just need to power...