Recent content by MattAune

I have been very happy with these. http://www.homedepot.com/p/Lithonia-Lighting-2-Light-White-Flanged-Fluorescent-Troffer-SP8-F-2-32-A12-120-GESB/100249370

I went with the newage pro series. Not so much for the 18g metal, more so because of the extra depth of the cabinets and the extra height of the lockers. Got the 10 piece set from Costco.com. So far I am very impressed. I suspect I would have been happy with the bold or the performance series...

That is an amazing view you have there. Very jealous. I also really like the doors on the garage, very well done.

Unfortunately, I don't have the tiles run all the way to the edge. I only ran them to where the Garage door touches the slab. I did look at a flat version of the first product you used. If you have used Tapcons do you think it would have held up? Am I better off just using the Armstrong VT8...

I have looked at two Home Depots and a Lowes looking for an Aluminum threshold to run the length of a two car garage door. Everything at the big box stores had pre drilled holed in it, I want something without holes that I can glue to the concrete. Anyone know where I can find something?

Thanks for all the advice. I did go with a concrete patch product. The product worked great, my concrete skills could use some work. Nothing a diamond grind wont smooth out though.

I am getting ready to lay some VCT down, but have a few questions. My slab was two separate pours (one car carport was extended into a 2 car) and has a relief joint right down the middle of the floor. There are also a couple small chips/divots on the old side of the slab. Other than that it...

My line is 4 individually insulated wires all inside a grey housing. I had no idea that separate wires were even an option. Seems like a lot more work, although watching the electrician bend the 4/2 looked like it wasn't much fun.

I am not an electrician, however my the inspector was just here looking at what my guys did to install a sub-panel in my shed. It involved 4/2 aluminum wire running in the ceiling joists of the basement without any conduit and he did not question it. As always requirements vary depending on...

Love the build. This thread has definitely pushed me over to the VCT camp. Still have that source for the tiles? I am a little southwest of you over in Annandale.