Recent content by mattdwelder

i do this every day. Use a car reamer and an impact. i could do a hundred holes in less than an hour and they would all be the right size.

Mini bolt cutters are mostly used for wire. It takes a big pair for bolts and locks.

you never put a vapor barrier in the ceiling

if its a grip latch then its a good box but price is still high

you guys are bad ***

looks good just a little hot

loc tite

the 250 will not run smooth at that high voltage, especially with straight c02, try 75/25 at 19 volts

i just bought a powermatic model 1200 and its missing the hand crank that raises the table up and down.I can make one but would rather buy one if anybody could help me out.

am i the only one who noticed that its not tig welded, looks like a mig weld to me

im a certified welder with 25 yrs in as a metal fabber. Currently im shop foreman at a local fab shop. I have access to a lot of drop pieces and any kind of equipment. I am in the middle of building a pole barn house and wanted a wood stove to heat the house and the garage. All the ones you see...

anybody built a wood stove ? any ideas ? any tips?

oil rig guys make their living with pipe wrenches and they wont use anything other than rigid

the company i work for has about thirty miller 252. these are probably the best all around mig made. I personally have owned a 250 and a 251 the 252 has those beat by a mile. I dont think you will have much luck with getting them to spray though.

i bought a set of these just to change the bits in my die grinder. work great!