Recent content by Matthew C Smith

Anybody ever see or try anything with pipe?

That certainly could look cool! I'll have to start looking at garage sales and flee markets!

I'm finishing up a set of garage cabinets/drawers in a workbench setup and am looking for different ideas for drawer pulls. Any interesting suggestions? Thanks!

I'm not sure what you ended up going with here, but I found something that others might find some interest in. I found this post after looking for similar and decided to leave this in case others found this as well. It's a couple recommendations for sloped unistrut channel such as may be used...

So what would you recommend as a maximum? Just trying to put some numbers in my head....

No problems with butted tight for me. I used coarse drywall screws as well. Did have some heads break off during installation if I drove the screws in WAY too far or tried to pull a gap up tight when two sheets were really tight. Other than that, no problems.

I'm in about the same circumstance here. I'm thinking I need a little more available output than the G73 offers. Does anyone know of a unit that's a step up from this? Something around 30K BTU perhaps?

Hi everyone, I've got an old detached 2.5/3 car garage. The ceiling height is around 8' with exposed trusses. The walls were insulated by the prior owner, but have not been covered. I'm interested in adding some heat for the winter but don't want to piss it all through the roof. The trusses...

Hi everyone, I've been reading this forum for quite awhile and thought I'd finally post. I'm looking to buy an air compressor. I've got it narrowed down between Eaton and Champion. Looking at 5-7.5 hp with a 60-80 gallon tank and about 15-25 cfm. I've heard good things about the Eaton...