Recent content by mbaker76

Looking for a couple of snap on sockets to replace missing ones. 1/4 drive 6 point shallow 1/2 1/4 drive 6 point shallow 5/16 1/4 drive 6 point shallow 1/4

Moved into a different house, old garage floor had floor drains, new one has sloped floor to the door. Water and slush runs off to the door and gets trapped and pools at the ends of the door where it transitions to wall framing. What is the best way to get water out and at the same time...

Yes I'm referring to the brackets to hang the door track from the ceiling. The angled them so that they could hit a ceiling joist above it's not a dramatic angle **** it does look a little off for some reason maybe just because my old house they were vertical. The ceiling is already drywalled I...

Just moved into a new house and notice the back hangs for the garage doors are angled forward instead of vertical. Its maybe 8" off vertical over 3 feet maybe 3.5'. I know the angle will create some horizontal and not entirely vertical force at the ceiling due to gravity but its also pretty...

I have an older set of the Cman hex bits, but have lost some of the bits from the sockets, or otherwise get annoyed because they slip out too easy. They need to be retained better or pinned like the snap on stuff. Maybe the new Cman stuff is better?

Needing to replace some of these and thinking of looking at whole new sets. Ive used some snap on that i really liked but cant justify spending the money for my every now and then weekend project, but when i use them i like to have quality stuff. Any suggestions? Saw some from Williams...

I am thinking of adding to my craftsman wrench set, on the large end (1 1/16, 1 1/8, 1 1/4) etc. Just to buy the 3 wrenches alone is almost the same as buying a set from 3/8 up. Would anyone be interested in the smaller sizes and split the cost of a set? Otherwise im going to keep an eye...

So I recently picked up a 3/8 gear wrench ratchet, the 60T version. It looks like a nice tool, feels good, and I like the short arc, but it keeps trying to reverse itself. If you are ratcheting along at a good clip all of a sudden it reverses and you have to flip the lever back. Almost like...

Looking to complete a set of snap on wrenches. Im in need of a SOEX14 7/16 and SOEX28 7/8, if anyone has some extras they might want to get rid of. Also have a SOEXm13 13mm wrench that coudl trade or sell if anyone needed it. Thanks.