Recent content by MexTex

If you are using one pipe for multiple bends, say you need to make an offset bend and then a doglegged 90 degree bend...where is your starting point for the second bend? I made offset bend just fine, but where do I measure from to make the next 90 degree bend? Thanks

I am about to tackle the electrical in my 40x40 shop. This will be my first experience bending EMT. Can someone recommend a good video or how to on bending EMT for beginners? Also, is it code to transfer from EMT to FMC with a coupling? I have some very difficult areas to get around due to a...

I am going to be running power out to my 40x40 shop within the next week or so. The distance to the shop is about 200 feet or less and I plan to run to a 100 amp panel. I had planned to run 2/0-2/0-2/0-1 MHF in 3" conduit, but is this overkill? Also I am having issues locating this cable. Is...