Recent content by Mglidew571

Thank you. Could very well be some (impatient) poor mixing.

I'm thinking router issue. It was a brand new bit but I played around with rotation speed, feed rate and even feed direction. I got mixed advice on pushing or pulling with surfacing bit. Like the squeegee idea. Thank you

Thank you. The pocked areas do seem softer than the other areas. I will mix more and pour.

OK I built the form, cleaned up the slab and poured the epoxy. The clarity, color and gloss of the epoxy river was more than satisfactory to me. I waited a week for a good cure and had no problems. I then built the router sled and started to level the surface. My once gorgeous epoxy river...

I'm retired. What is a $100 bill?

Okay. Change of plans. I built the router sled, bought new router bit and did everything according to what I've read. The problem is, as shown in the photo, when I pulled the router across the (once glass smooth epoxy) I raised half a dozen spots that look like my epoxy got a bad case of Acne. I...

Let's get right to it. The only thing I know less about than wood working is how to navigate a forum. I've started an epoxy river table. I've poured the river, cleaned it up some and now I'm to the point where I need to "level" the surface. I do not want to build, buy or otherwise use a router...