Recent content by Mike~MIller

A variation on Beeswax was going to be my other Suggestion. its cheaper than that Museum Wax I mentioned, :rocker:

This stuff is TOP notch ive used it for long term storage. even used it on Guns to keep them from rusting.

You haven't Changed a filter on a 92 2weel drive Pickup with the 2.4 then. usually, i would just leave the damn thing in there for a few changes.....

thank you for the great info!

From What I remember this problem comes up from time to time with this vintage of Engine, What I've found is that its the intake gasket at the rear of the engine has either deteriorated or more commonly the nasty ****** ethanolate fuels our kind and a Gentile government has force fed us has...

What is this? any ideas..

I found one!!!!!!!!! Holt grail they did make this tool but from 1995-2001 so the one I had, I know was Wayyyy older but check this out. Snap-on F50CSA 3/8 drive spinner handle

will do this could be very cool to share.

After doing some Research and Speaking with my uncle. That Particular tool I owned was not one that I Purchased from the snap-on truck. it was one modified by my Grandfather. now I'm more saddened by the fact it was stolen. Seems I have NO choice now but to Redeem myself and Re-Re-make it. I'm...

Like I said I had one before from the snap-on man. but it was stolen. at this point, I think ill have to make one.

Do you have a pic? I never thought this would be so difficult to find...might have to make it.... is yours standard length? This one is the 1/4 version but it's the setup I'm looking for just in 3/8 http://www.worldimporttools.com/upload/save_image/12271344_50dbd22f3f228.jpg

Hellow there, I'm looking for the Part number for a Specific tool. The Snap-on Hard Handle Standard Length (not Stubby), (not Long) I have Those #'s, 3/8 Socket extension/ Hand Driver W/Square drive on the rear of the handle. I Had this EXACT tool but due to my car being Broken into and Half of...