MikeC55's latest activity
-
MMikeC55 replied to the thread 240 V electrical.I had no issue running my 10-3 and 12-2 romex in the 3/4 conduit. It was only a 5.5' length and straight. If there were any bends, I'm...
-
MMikeC55 replied to the thread 240 V electrical.Yea, I'm the only one using the lift. I ain't gonna worry about it. Got it all hooked up and tested today. Works fine!
-
MMikeC55 replied to the thread 240 V electrical.I did post a photo of the motor name plate in my previous post. It clearly says 'not thermally protected'. I found these, but would...
-
MMikeC55 replied to the thread 240 V electrical.I haven't been able to find a single one rated for 30 amps with 4 terminals. I wonder if I could use a 2 terminal on each leg?
-
MMikeC55 replied to the thread 240 V electrical.Thanks, guys. I think I'm going to run my 10-3 and 12-2 romex through the same 3/4 (straight conduit) to the power disconnect switch...
-
-
MMikeC55 replied to the thread 240 V electrical.I was thinking you could buy BX armor and run your own wires in it (like conduit). It doesn't appears it sells like that. I guess I...
-
MMikeC55 replied to the thread 240 V electrical.The walls and ceiling will be insulated, so I plan to run the 10-3 romex to a box directly above the power unit post (the motor/fluid...
-
MMikeC55 replied to the thread 240 V electrical.Yes, single phase. I will forego the outlet. A short extension cord will do.
-
MMikeC55 replied to the thread 240 V electrical.I have to provide the power disconnect switch. I did buy a double pole, 30 amp rated switch for that. Here's a related question; since...
-
MMikeC55 replied to the thread 240 V electrical.I'll get a photo of the motor tomorrow, but here's the wiring diagram in manual. I expect the motor will show 208-230 VAC. I guess...
-
-
MI'm getting ready to start wiring install for my new lift. It needs 240 V / 25 amp and I've got my 10-3 romex and 25 amp double...
-
MMikeC55 replied to the thread How do I insulate an existing, finished garage?.Unless you have a pretty steeply pitched roof, and/or large rafters (2 x 12, etc.), drilling holes in the wall header may be pretty...
-
MMikeC55 replied to the thread Source for metal ceiling panels?.I've had some delays in the schedule and haven't purchased yet.
-
MMikeC55 reacted to Chevy-SS's post in the thread New Bay Window: U-factor not met, Inspector says need new glass, will argon maybe meet new code? with
Like.
HOME DEPOT COMES THROUGH WITH 50% DISCOUNT!! :thumbup: For those still reading: Home Depot came through for me. Today I went and paid... -
MMikeC55 replied to the thread New Bay Window: U-factor not met, Inspector says need new glass, will argon maybe meet new code?.Agreed. I believe there are situations where stealth remodeling is worth the risk.
