Recent content by MilhouseW

I was thinking/hoping something like this would be possible. After you mentioned that I did a bit more research and found this: transformer relay (model 24A01G-3) I think this will work well for my setup, and I've been able to find it for ~$65.

Thank you for the replies. I had been hoping to not use a line voltage thermostat due to the location the termostat needs to be in, but if that is the case I can consider it. I have not looked at line voltage thermostats before, but would one that controls 120V be sufficient since it's only...

Awhile back I purchased a Markel (TPI) HF5600 series 240V 5000W electric heater for my garage. For the past few years I just had it hanging from a temporary bracket and plugged it into my welder outlet. I'm finally getting around to mounting it on the ceiling and install a wall mounted...

Re: E-tek Resto's 56 Chevy Truck E-tek, I'm not sure if you mentioned this before (and I'm sorry if I missed it), but what do you do to prepare and setup your garage before you do any sanding and painting in there? From the pictures it looks like everything is still nice and clean, and without...

Re: E-tek Resto's 56 Chevy Truck Just a slight correction Roofster - the 3100 is the 1/2 ton short bed, 3200 is the 1/2 ton long bed, 3600 is the 3/4 ton, and 3800 is the 1 ton.

Thomas, I've been following your thread for some time now, but have not posted until now. I commend you for taking on such a project and think it's wonderful that you've kept a garage with so much history alive, and still use it for it's intended purpose. Great work! I have two thoughts on the...

PM sent...

Looks great! I'm looking into doing something similar in the next few months and I'm currently in the planning/budgeting stage. Just a couple of questions I had for you... What was the approximate cost for just the cleaning supplies, and then the epoxy/clear itself? How long did the project...