Recent content by mjchamp

i had the same issue. I used a handdeld planer

Mini split is set to 50 Degrees 24/7 Then, when i need to work out there i turn the natural gas heater on to 65 degrees. Best of both worlds

I store my M18 tools in a file cabinet and my M12 on peg board. works out well

i use a small ports organizer https://www.menards.com/main/tools-hardware/tool-storage/storage-racks-containers/plano-reg-24-compartment-small-parts-organizer/532430/p-1444450814379-c-9189.htm?tid=3271164328182768307&ipos=59

Jakes Off Road. Jake good does amazing work, https://www.facebook.com/Jakes-Offroad-and-Fabrication-104099394309823/

looks like the prices are back to "normal" now on their website

Blitz Black. You can get it at your local John Deere store

Get the tallest door you can fit. You will regret not getting a tall door someday (speaking from experience)

Zero-G

Do NOT get an axle for splitting firewood. Get a splitting Maul. I have used this Fiskers for years and love it. https://www.amazon.com/dp/B014M9LQGG/?tag=atomicindus08-20

I sure do, and I love it. Especially for remodels, no noise from a running air compressor.

This is what I am using. It is a 20 .lb liquid CO2 tank. I can shoot thousands of nails before needing to have the cylinder filled again. Best part is that it is silent (no compressor running inside a house)

I don't like the look of painted OSB either. So I used 2 coats of block filler after the primer It made the wall looks much smoother.

A plasma cutter

it will take lots of work to make that wood flat. I would use it for a base to something. Or just split it and burn it for heat