Recent content by mk77

Alright, thanks. Would a main disconnect on the outside of the same wall be acceptable? Would both the main disconnect on the exterior of the garage and the main lug inside the garage be considered sub panels, where the ground and neutral are separate?

Attached is a picture of the meter socket and panel on the exterior of the house. Honestly not sure why I opted for the main lug rather than a breaker panel. I suppose I could switch it out if necessary. Yes, something needs to be done about the rust and the wiring could be cleaned up.

After almost a year and a half of working on my garage I’m finally planning to run power to it. I have installed a 100 amp main lug inside the garage. The over head power connects to the meter which connects directly to a disconect below it. The disconnect has a 200 amp breaker which supply’s...

I'm from your area and I'm looking into also getting a building. I've been looking at superior and Tarheel. If you don't mind me asking. Is your building the engineered/certified 12g? And did superior do the concrete as well?

I think that the foil fiberglass insulation that they offer would definitely be better than the bubble insulation.

Is that the bubble wrap style insulation or is that something else?

I've been looking through the forums the past week and I finally decided to make an account today. I know there are tons of metal building insulation and condensation questions on here, but they all vary and don't specifically answer my questions. I'm planning to build a 24'x30' prefab metal...