Recent content by mkastens

Need some help on how to set the blade depth dial gear. I totally forgot to snap a picture of how things were set when I took it apart. I just want it fairly close but I'll always measure anyway.

Making some forward motion but still a little puzzled. Took it all back apart, took the starter relay apart and did a super clean, switch is nice and smooth and all contacts are like brand new. Putting it back together there was no catch on the spin motion after I tightened the frame screws...

Thanks for the reply torqueman2002 So I've pulled and cleaned all wires and connectors, I've made sure the connections matched up to your diagram, (which matched my tear down photos) Still no luck? Are the starter relays available for purchase> I've tried to cross ref to something available...

Recently restored this 397.19340 Block It was working well when I took it apart. I took picts of all the wires to make it easier to put back. I cleaned, regreased, and put back together. On first start the motor just hummed, I could start the spin if I helped by spinning the shaft. I could also...

These stickers are amazing, I was just working on my grinder restore and was wondering if there was any way to get a replacement sticker. I hope these are still being made and what do I need to do to get the sticker below? Please let me know, I love how dead on the reproduction is.