Recent content by mobilesport

I have a box van with 2x2 inch square tubes that stick out of the rear bumper barely , there's 2 of them , i made 2 ( 1.75x1.75-----12 inch) long square tubes and stuck one inside of each of the vans 2x2 square tubes, I only stuck them in 6 inches so there's 6 inches sticking out of each one as...

I found a nice big steel building and lot for sale but it has a dirt floor , do you think it's possible to have a slab poured into the existing building ? I,m just wondering how it would be possible because I can't think of how they would deal with the edges , like would the steel building act...

That's genius , i'm gonna do that

That's some really good info about the slip plate

I was at Home Depot today and I never even really payed no attention to the Ridgid , my eyes where going back and forth between the Milwaukee and the cheaper Ryobi , I know some people may have low opinion of Ryobi but I've had really good experiences with Ryobi so far . One thing that I noticed...

I was at Home Depot today and I never even really payed no attention to the Ridgid , my eyes where going back and forth between the Milwaukee and the cheaper Ryobi , I know some people may have low opinion of Ryobi but I've had really good experiences with Ryobi so far . One thing that I noticed...

I was thinking 1/4 " would work for me , just to zip screws in and out.

I'm looking for a small lightweight CORDED power drill , I plan to use a xtra 9' ext cord with it . I was thinking of getting a cordless but it seemed I would'nt gain anything by it because I would lose the cord but then have to deal with added weight of a battery , plus batterys going bad ...

Another picture [/URL[/IMG]

Ok , got em the right size , Thanks Zkling

LoL , I've been trying to figure out how to put picture up from phone , no luck Photo bucket says to just tap and hold on html code and it will copy to clip board , does' nt work Ok , but now how do I make the pictures smaller?

7 foot tall 12" deep Oak tool chest cabinet mounted to wall ,,, L.E.D Lights accross the top ,, The shelf to the right is 7 foot tall and holds power drills , jig saws, sanders etc. And the power cords just dangle so I dont have to roll them up https://imageshack.com/i/f20q2vj

I want to build one like this , How wide and deep did the trenches have to be ? Also in the pictures on your website it showed osb plywood being used for the Concrete forms , how'd they get the osb boards out of the trench after the concrete dried ? I would think that the osb would have stuck to...