Recent content by Moose-LandTran

Why? I have a set of Gearwrench and they're really good.

I've never come across an E16 torx bolt. I think it's a made up size to fill out sets and make them look better. Like E22, which i've also never seen. It's why most sets skip it.

65mm for hub nuts:

A friend asked for a stubby screwdriver with a big flat blade in it. Found aspare handle and blade, made this for him: Liked it so made myself one too. The blade is from an SDD8, cut down then two weld beads put on it, ground into tangs then pressed into the drilled-out handle.

Hazet make a compact ½" ratchet. I have two of the old Snap-on compact ones.

My full set of Bahco (made by Irazola) Spanish stubbies. I really like these handles and it's nice to have PH1/PZ1 in stubby too. Such a shame that Snap-on Europe seem to have killed off Irazola as its own brand. They make/made excellent screwdrivers.

I have a Hazet/VW pair like that, so useful. They make removing door cards so easy.

Full set of Bahco/Irazola stubbies.

Lisle, don't bother with anything else.

The few i've used haven't. Once the codes are cleared (and fault doesn't return) they're gone forever. May be different on other/newer systems.

PB Swiss or Wera, i have both. PB is definitely the best i've used, unbeatable. I had a Snap-on set and sold them, wasn't at all impressed with them. The fit and strength of the tips was nowhere as good as Wera, let alone PB Swiss.

My ⅜" deep Torx are Hazet. Shouldn't be too hard to get if they're in budget.

Yes, they're squishy rubber.

I have two of those, not Blue Point branded but identical generic ones. (I think they're branded Franklin.) They'll work just fine. I've beat on mine pulling seized hubs and pinion drive flanges and they take it.