Recent content by Moprar Racer

  1. M

    No ventilation ?

    Do i run the soffit baffles under the insulation? (Attached to the decking/shething) So take down the insulation, run the baffles from soffit all the way to ridge vent then put the insulation over the baffles, Each rafter space should have the baffle, and then a continuous soffit under the eave?
  2. M

    No ventilation ?

    Mine are stapled also.Is you garage ceiling opened with just insulation in between the rafters? Any vents in the roof?
  3. M

    No ventilation ?

    Yes insulation is exposed. I am doing a new roof this weekend and going to install roof vents (6) I am thinking of finishing off the ceiling and adding blown in insulation and a pull down stair to access it. The attic is open right now and not sure on to drywall and just use 4x8 osb on top of...
  4. M

    No ventilation ?

    1. Wood stud construction. 2. 15yrs. old 3. Plywood roof. 4. Soffits vents on eave about 4 on front and rear. 5.Electric heater. 6. No vapor barrier. 7. Illinois, northen 8. Heated in winter, cooled in summer. Its the issue in summer months. when really hot out and the air is on the insulation...
  5. M

    What to use on shop floor?

    Hello, We have a 20X40 garage used for automotive repair, engine hoist, floor jacks stands etc. We want to finish the concrete this winter and was not sure on what epoxy will hold up. Any ideas? I finished the garage floor at my home with epoxy from Rustoleum and it holds pretty good for light...
  6. M

    No ventilation ?

    Hello, great site and first post. I have a 40x20 garage, that has a wall electric ac and heater combo. The rafters have r-19 batts insulation and one roof vent. We have moisture on the insulation which at times will drip to the ground. And now mold has formed. The roof has no ice and water...
Top Bottom