Recent content by MortyNTenon

I have thought about doing this also, only on a smaller scale. 50 gal oil, 50 gal of hot water to keep temps stable inside the box. Divided in half incase of a fire and a diesel startup fuel supply if the fire goes out at 5° and I'm gone for a couple days. Working on a mini split instead...

I have to exit the right side of the indoor unit with the line set. Should I leave the factory 90° bend and just swing the lines over or straighten the 90 by bending down and then back up? It's 1/4 & 3/8 lines with a factory installed spring type bender on the 3/8 line.

Was trying to stay at 5 hp for electrical reasons but that would be nice choice also.

Where's the video??? This should be sweet. I'm looking for a new compressor and have narrowed it down to a VT 735 over the Champion models. Then while looking for a good price I discovered that SB offers a 707 and a 5 hp motor (737). I haven't found any videos to hear if the lower noise...