Recent content by motart

i installed a sterling gg60 myself @ xmas time that i purchased from here http://www.littlegreenhouse.com/accessory/heaters4.shtml. installation was straightforward with given directions and i couldnt be happier. also installed the optional concentric vent kit. heats my 24' x 32' x 9" from...

emailed u

still on the hunt 3 years later. anyone parting with one???

dave and bd, thanks for the replies! i also had a thought of mounting and venting heater over forward most side window so that the heat will blow across the the area right inside of the doors. i might be just overthinking all of this as the area is only 768 sq ft ? and placement might not be...

through much reading here on the journal, i am in the process of purchasing a hanging unit heater i.e. sterling, hot dawg, to replace my existing lp vented wall furnace. this wall furnace is currently installed in the middle of my 24' side wall of my 24'x32' building. this makes the...

pm'd u ricky

if needed i have an: OEXM120B 12MM COMBI SOEX13 13MM FLANK DRIVE COMBI no initials or markings $15.00 ea. shipped or trade for oemx80b, oexm90b, oexm210b

have a set of torx drivers from true value (master mechanic) if you're interested

i need a oexm100b 10mm combi wrench

sent private message

still on the hunt guys!

still on the hunt guys!

still lookin

still lookin

looking for a red (if possible) handled late 90s style #3 philips screwdriver-thanks