Recent content by Mountainman

Here are a few photos.

I would have them demo it and start over. I hope you got a copy of the contractors license and insurance. Start with the building inspector. He may be able to help.

I have got m. BendPak 10 k lift installed but now I a can not get the safety lock to work on the non power side. When I tighten the cable to where the lock will release tHere is to much tension and the lock will not spring into the lock position. I have checked and tried everything I can. Seems...

Just added photos.

I am installing my 10k BendPak two post lift. Everything was going good until installing the last four anchor bolts. The last four 3/4” x 6” bolts tightened up but there is only about 3” embedded in the concrete. The other bolts are embedded almost all the way. I am not sure why this happened...

I am about to replace my 200 amp meter base with a 400 amp meter base with two disconnects. One for the house and one for the shop. Can you post the photos of what you did and how you wired them? Thanks!