MP&C's latest activity

Check the McMaster link here: https://www.mcmaster.com/products/~/aws-material-code~er70s-7/?s=er70s-7

found some time for my C.O.E this week so decided to build the steps into the sleeper. got a good start before running out of material

I am no professional but have done my fair share of panel replacement. You will be satisfied. No sparks compared to the grinder and...

Depends on the position & what you are doing but all of the above can be used if that's on hand! Do you have a set of panel splitters /...

We went to the show about three years ago, very impressed. Even got in a tour of the plantation while we were there.

Thanks for the offer Robert! Would love to stop by, but I won't be able to make that show. Have lived in this area nearly all my life...

Anyone in the area, we’ll have the 66 along with the speed boat at the Fathers Day car show at the Sully Historic Site, located at 3650...

Chances are good they're toast. They might light up and leave a bead, but the flux absorbs moisture from the humidity in the air. This...

@larry4406 the “leverage” tool that I used to take out the incorrect bends was also used to add the correct ones back in. It’s...

Larry, you can bump a curve that size pretty easy. That is how I did the fenders for the rolling tool bench- 1/8" x4" flat bar. I just...

Real big tree or wrap it around a tire. Does it have to be 3/16? 1/8 would make it so much easier. Other than that, find someone with...

Nice work. I've spent a lot of time at PAX River. Camped on base a few years ago too. Zim

Had an insurance job in the shop, a collaboration with a local collision shop. One of those fancy, old-time looking hearse had a...

For MIG wire on sheet metal I prefer using ER70S-7. It has a slightly higher Manganese content for better wetting, ie: flowout. So...