Recent content by MrVette

Problem with the Bend Pack as I see it is you need an air supply to operate the release. I'd rather have a mechanical release so the caster kit can be used to move the lift as needed and outdoors for pressure washing the underside of vehicles.

Sounds like good news for us low level C5 and C6 Corvette owners.

I have early Corvettes (50's and 60's) as well as a C6. I've been looking at the HD-9st and HD-9stx since they have an overall width of 100" to save space. They have a 90" pass through width. My C6 is 72" wide and it would seem that a 90" pass through should be sufficient. I understand you were...

Other than the weight did you have any issue getting a C6 up using the original length ramps? I'm fixing to order a lift and was planning to get Bendpaks aluminum ramps. Just wondering if they are long enough not to cause any ground clearance issues with a C6. I gather the aluminum ramps are the...