Recent content by mryanangel

No I dont have them. Do you know a good source for them?

So I ended up taking a job in UT in early 2018, spent a year flying back and forth every week, before moving the family out there in March 2019. Since we were renting a place, I put the 325 into storage, where it has sat until a few months ago when we finally finished building our new home...

Keep playing with the construction section of the application, it's just a matter of placing rectangles and cylinders appropriately. Once you have your space modeled then worry about the lighting (luminaries) Location: Chester, NJ

This is the same ROC as my pump. I may need to go take a look at that. Location: Chester, NJ

When I first started the motor up it was slipping, so I tightened the belt today before making this video. It isn't slipping any longer. Location: Chester, NJ

If I can get away with $500 I'll be happy. If I have to drop another grand to get this right, I'll be less happy but deal with it. Is there a good rebuild thread or service manual out there that anyone is aware of? My ROC is 104. Location: Chester, NJ

I will post up what I find and ultimately how I fix it. Location: Chester, NJ

Wow, your connecting rod was in pretty rough shape. If you don't mind me asking, how much did you have to invest to rebuild your compressor? Location: Chester, NJ

I'll pull the cover tomorrow and take a look. A Loose bearing cap wouldn't be too bad, I have a feeling it maybe something more sinister though. Location: Chester, NJ

So I put on a new air filter, changed the oil, gave it a paint job, installed a new single phase 5hp marathon motor, ran a 50amp circuit to my new magnetic starter, replaced the pressue guage with a 200 psi liquid filled one and fired her up. Good news is she builds and hold air. The pressue...

Start by making a hand sketch with all your measurements, then use the construction section of dialux to build your model. It takes some trial and error to figure out the application, but step 1 is building your model. Location: Chester, NJ

Wonderful, thank you for the guidance...and teaching me how to fish. The dialux application seemed daunting at first, but with a little trial & error it started to all make sense. I am sure I don't fully grasp all the various calculation angles etc. But the basics I understand. I will post up...

I updated my model using your IES file, and slightly rearranged the fixtures. This is what I have come up with. Does this look like a good plan to move forward with? Floor Surface: 67.2 FC - Average (The majority of the area surrounding the vehicle is 75FC) 0.0 FC - Min 105 FC - Max...

Thank you very much. When I get home this evening I will download your IES file and take a look.

I think I figured out to use the Dialux application. I modeled my garage and then started arranging lights based off of the above recommendation and info found in Platonic's best light fixture thread. I couldn't find my samsung bulbs in their inventory, so I added the specs manually (3800mn...