Recent content by Mscdman

I’m working with a garage door company for the install but they couldn’t tell me where the door would open to. Length of the track isn’t an issue as it’s away from what I’m storing on the ceiling.

I can afford to have the door when open sit a few inches below the garage opening which will help

Gotcha thanks. Also noted about adjusting the travel of the door if it’s a few inches off

Thanks ninja. 44 or 45 measured from what point of the horizontal track? From midpoint of radius arch? Or from the wall behind the track? Or are you saying 44-45 from after the radius

But a min distance and a max distance (range)I can expect will help too. If it falls in between it might be okay

Need as exact as I can. Every inch will make or break this project. Each panel (4 total) is 21.5 inches

I’m working on a project where how far back the garage door goes back horizontally when full open is very important. I’m installing high lift track (probably 12 inch radius). Measurements as follows: * floor to ceiling 125 inches * headroom 41 inches from top of door to top of ceiling. *...

Thanks. Is the same true for the larger 1/2 drive standard larger MM sizes in 6-point? I can find all the way up to 36mm in 12-Point but not 6-point... Also I’m assuming the 1/2 inch drive /32nds also dont exist in 6 point. I also have those in 12 point but 6 point no where to be seen

I’ve been on the hunt for some time now trying to “complete” my craftsman socket set. I don’t care if it’s new or old or a mix, as long as I have a craftsman set. Here is my dilemma: I’ve never seen many size sockets from craftsman. Not sure they exist. Example: 3/8 Drive...