Recent content by msink

Yeah, here is what they said :) Mark, If you need to re-pour, the recommended size is 2' x 2' x 1 foot deep. See attached. Regards, Julie Demdam 844-629-5291 ext 128 Yep 2'x2'. The attachment showed what for me would be an 11'x6'x4" slab. But even one slab connects both of my existing ones...

Did your holes span joints meant to separate 2 slabs. That’s my issue here.

It is keyed

It’s a MaxJax mx-6. No cross beam. 6000 lb max. 45” lifting heigh so less torque on the tilt issue than a full height lift. To the left of this hole is the other hole. So orientation is left to right. Post goes in th middle of this hole. Thanks for link and info.

Thank you!

Thanks a lot folks! A few answers: Hi haven’t poured anything yet I’ll be using epoxy anchors I’ll be using 5000 psi bagged sakrete I was a little worried about doweling. Slab is only 2.25-3.75”. Just drilling straight down for the anchors that never grabbed wasn’t that easy. Cheap rotary...

I need some help. I was going to mix and pour this weekend but decided to get advice on this first. My floor had a flat piece of metal separating the 2 halves of the floor. My new pad would essentially join these 2 halves now. My pad is 3x3 for the first 4", then 4x4 for another 4" (8"+...

Did you get the Exige off the ground? With my dry fit test, and arms fully extended, I think I ended up at 121" Anything more and I wouldnt be able to lift Elise. Ive got the MWR lift kit, but not installed. Im still dealing with anchor issues that failed to set properly. With 4" of concrete...

Any answers on this one?

I did my first dry fit last night. Man.. I was not expecting things to be so picky. If only the arms were longer... Ive got an Elise, MR2, and 370z so I just test the Elise and 370. i *THINK* i can lift both if I pull in between JUST right and pull up JUST right then I can *JUST* reach the...

Ok folks, my MX6 was just ordered. I went through a few ignored emails trying to get them to adjust their Amazon price to match their website. Some of you might have rewards card for using amazon. Mine gives back 5%. So I just ordered mine from amazon. I called to confirm it includes all the...

How centered, left to right, does the vehicle need to be between posts? If it's offset 12" or even more, is that going to be an issue? Imagine posts are where I want them to be, but ceiling obstruction requires vehicle to be pushed to one direction to clear obstruction. I'm thinking MX6 here...