Recent content by mudfly

This one is very basic, but also very easy to use. http://www.floorplanner.com

Here's what I used. I purchased a 3M respirator with 2091 (pink) filters off amazon. The Dust Deputy. The Diamabrush with the Clark floor polisher from HD. I dreaded this procedure because of all the dust I'd heard that was produced. As it turns out, my dust situation wasn't that bad. At...

Thanks for the advice..the crack chasing blade suggested would definitely do a better job with the tapered blade. Also the masking tape prior to epoxy is a great tip. I decided last minute that I wanted to knock this out over the weekend. Unfortunately, I wasn't prepared with all my...

I'm in the process of preparing my floor for 18x18 VCT. I know the VCT debate and have added a few gray hairs in the decision process:), but I'm going for it. I have a few cracks that run the length and width of my 20'x25' slab. After researching this board, it seems the consensus is that I...

test

test

I have a similar situation. I'm going to try this stuff on my poured concrete walls. Couldn't find at any retail stores, but the local Sherwin Williams ordered some for me. I smoothed the walls a bit, but still a little rough from the forms. If I paint with a regular paint, especially any...

Misery loves company:) Here's my cracked concrete story. 20'x25 slab. Long story short...Walls and footer poured with concrete truck backing up my driveway to new shop located behind my house. I have no problems with that pour. A few days later the crew (same company, different crew) shows...

Just discovered you guys a few days ago. What a great source of information and entertainment. Now I see why they say this internet thing can be addictive! Anyway, I'm the process of building a detached garage to "hopefully" build an airplane in one of these days. Had most of the structure...