Recent content by multmin

Hello All! Great ideas around this topic. It took awhile before I found slatwalls - I'm just now returning to this post and seeing that I missed everyone's great suggestions! In the interim, I found slatwall, Geartrack, Versatrack, Toolflex, DIY with channel, French cleat, etc. Should've...

Hi Leafless! I did see that, but the T-slot seemed to fit 1/4" bolt heads. Possibly there are some wider T-slots? EDIT: Miter T-track comes closer in dimensions. Perhaps we'll figure it out eventually here.

Thank you for the replies. Cobbler, I'm honored! Stuey, I'm not worthy. I've been reading Toolguyd for many years! I thought of a custom extrusion, but there are so many sellers offering it. It's all over Aliexpress and Amazon from different sellers AND in different lengths, for instance. It...

When searching for broom/mop hangers, I found several that all used an aluminum track system. I cannot find the raw aluminum track product. I've searched channel, track, rail, guide rail, etc. I'm looking for just the raw aluminum product - no hooks, attachments, etc. Just the rail itself...

Sorry to bump this back up, but I've watched this thread a long time and now have a question. Does anyone have the Channellock 39100 Ultra Access Set of pass thrus? From the pictures, I cannot tell with certainty what type it is. It looks like a hex with a check ball, but what is the sizing? If...

Please pardon the bump, but I'm looking for an answer on coupler size. First, thanks to the OP and theoldwizard1 regarding pot metal, heating couplers, etc. What is the Milton V model number for the couplers that everyone is talking about modding their CAT compressor with? S-765 or S-767? Or...

I had to jump on this when it came back in stock, too. Thanks to theoldwizard1 for his posts on the 4620 regarding pot metal, heating couplers, etc. http://www.garagejournal.com/forum/showthread.php?p=5063737 That being said, what is the Milton V model number for the 3/8" couplers that...

On this topic, which Milton V model number has threaded ends that fit the CAT compressor receptacles? I figured it'd be better to get the 3/8" NPT for the coupler side but wanted to check the thread end.

Shame I'm in DFW - I'd buy two of those attic air ventilators if they aren't rusted inside. Edit: They have flex duct, too? Gee, I wonder what size(s).

Thank you, Skin! I saved on some sockets I'd been wanting.

Someone is selling the HF US General tool boxes - the 44", the top chest, and the side - in the DFW area. Could be the early ones with the crinkle finish, but I can't quite tell. No affil. http://dallas.craigslist.org/ndf/tls/4622420276.html

Ah ok. Thank you for your answer. Since this is online ordering, how does one know if the tool was made in the U.S.A. before getting there? Or is it a guess?

Did you order online then go into the store to choose your wrenches? Or just go to the store?