Recent content by Neto_09

I modified it to go either direction. So far, I had modified 3!!! And it’s possible to do it, you just have to do some research!!!! I had great help from dogdog!!

It’s one of those “Taiwan” made motors. It was complicated for me at first to understand which wires are which, but with the help of @dogdog, it was easy

Hi dogdog!!!! Here I am again!!! Lol. I thought about use one of those, but for me, it’s kind of bulky.

I have a drill press and I just modified the motor to go CCW and CW. I don’t want to have to switches to control the drill press, so, I want to know how to wire the 3PDT toggle switch. I’ll appreciate any input. Thank you

I found a 1 1/2 hp for $30, I’m going to sell this ones that I have and mod that one too!!!

Thank you for all your help and your patience!!!!!

Dogdog!!!!!! I did it!!!!! I reversed the motor!!!!!!!

It looks like there were two attached to the yellow but it might be a smudge and make it look like two wires.

One question. In your motor, your color wires, how many winding wires were connected to each wire? In one of the pics that you posted, the yellow wire seems to had 3 wires, because I can barely see that there are two crimped to the yellow wire and the one that you separated and crimped the black...

Ok. I understand. I’ll check later. I’m running some errands

This is what I found today. All 4 wires. 2 have 2 winding wires, one has 2 winding wires and it has attached a wire that goes to the centrifugal switch and the one on the picture that shows 3 winding wires. Is this the one!!!!

I’ll dig deeper on the fiber glas tubes then. I have cotton strings, plastic ties and the silicon heat shrink. ?2 and ?1 are the ends that I found, they were soldered together, i unsolder them and that’s how I got them. ?2 and the wire that goes from the cap to the windings, seem to be the...

I measured ohms. 2-3 =1.2 1-4 =1.2 Wire to cap + ?2 (end wire)= 1.9 Now I measured ?1 with the ones that have continuity and this what they read: ?1+wire #4=3.1 ?1+wire #1=1.9

Hey, you know more that me, so, that makes you an expert. I found something, I hope you can still guide me. In this one, I follow the wire that comes from the cap, there’s only one wire that goes into the winding and gets lost On this one, ?2 it’s one of the “ends” that I found into the...

Thank you for your input. That’s why I prefer to ask the experts.