Recent content by nippaero

Hi folks. I am looking for a coupon for a 2" water pump. Do they ever go on sale?

I used this one yesterday. Great tool chest and price. :rocker: Now I just need to find the top chest on sale. I tried to use a previous coupon but it was expired on 10/31....

Thanks. If anyone has a single side scan coupon for it I would appreciate it. I plan on picking up the bottom cabinet tomorrow.

Hi guys, Does the 44" tool cabinet top chest ever go on sale? http://www.harborfreight.com/red-roller-cabinet-top-chest-68787.html

I had to stay 10ft away from mine when I built my shop last year.

Are you saying not to screw the B vent joints?

Guys, how did you connect the vent to the back of the heater. Did you add a couple sheet metal screws to keep it in place or use tape or? Also, I see some of you are using a firestop plate where it goes through the ceiling. I was going to just use one half of a wall thimble. Any problem with this?

Perfect. Thanks!!

I just bought a Honeywell CT31A for my 45K heater. I am thinking I may have bought the wrong thermostat. They back of the heater has the following terminals: C W G R The Thermostat only has Y G R W Did I get the wrong one?

I used Super-Strut for my 45K unit. I got everything at Home Depot. I used the spring loaded nuts and 3/8 threaded rod to install. I just bought my venting yesterday and will start installing today hopefully. I am going with 3" B vent all the way. Next I'll be trenching the gas line from the...

It's 24x24. The ceiling is vaulted 9ft at the wall and around 14.5ft at the middle. Thanks for the help guys. I haven't pulled my permit yet and still have to figure out the venting. Also need to run my gas line fromr the house. Will probably do it this fall.

Great. Thanks. I am guessing as long as I only run it in fan only mode it won't matter if the gas is not hooked up.

I know some of these question have been beat to death but search is not turning up anything easy. I just installed my heater on the ceiling. I have not ran the gas line or vent yet. I'll probably do that sometime this fall before it gets cold. Can I run the fan on the unit to circulate air this...

Well, it turned out great! Thanks for all the tips. No bleed through and the edges are nice and crisp. Even on my textured surface. One thing the lady at Home Depot said helps is after you apply the Frog tape wipe over it with a damp cloth. It helps activate the adhesive to prevent bleed...

Lots of good info. Thanks! I am making progress and using the method described here http://www.frogtape.com/FrogTape%20How-To/How%20To%20Tape%20on%20Textures.aspx Got everything taped off and the first coat is down. Hope it turns out good!