Recent content by npmako

I dug a sump between my lifts using a 12" plastic pipe (with holes/perforations drilled to catch water under the slab) as the casing. The drains in the scissor lift pits flow into the sump and are pumped out with the shop floor drains. I'll try to get some pictures.

I recently incorporated both a rotary two post in ground as well as the Atlas flush mount into my new pour. The two post is far easier to get right, but if you’re forming scissor lift pits make sure you get the bottoms really flat while finishing. I spent a day grinding to make up for my screw up.

Most definitely communications duct....now it will fuse up (to the blue electrofuson fittings) and work for water, but not at all recommended or approved for potable applications.

The ubiquiti nanostations work extremely well for point to point bridges, but if you have the ability to install a conduit definitely consider fiber. It's inherently dielectric (unless armored and you're already in a conduit) so lightning isolation will be covered. Pre-terminated assemblies are...