Recent content by nso123

We use Ross pistons in everything from street applications to race engines. There is a whole lot more to a piston than just machining it to fit. Placement of the rings, gas ports (if applicable), etc. The pistons are designed for specific applications, so a naturally aspirated piston is not...

Thanks for your offer, I really appreciate it. I wish I had some of the nylon or Delrin stock, and I would turn it down on my lathe.

This is actually a bulkhead fitting, and it is leaking around the area where the fitting goes into the fuel cell. They come with a nylon washer, but the washer needs to be a little bigger to seal. I will check with Ace (my local Ace is not the greatest), and if not, the link above will get me...

Yes, it would be a critical part because it is for the fuel system. I have a leak around the edge of a fitting on my car's fuel cell, which should be easily fixed with these washers.

I am needing a source for a size 1.125 nylon washer. I basically need an I.D. of 1.065 inch. I only need 2 of these, so a retail source would be fine as I would hate to have to order $100 worth of washers for a minimum order.

What about welding a piece of flat bar stock on each side of the gate, one to the gate itself, and the other side on the fence? Do them opposite of each other so the gate will still swing. You can leave the base of the lock exposed so that you can still get it unlocked. Also, if you are...

I have seen these on gates before. They were basically a three sided box that the lock went inside, which protected it from being cut.

I am looking for a set of Snap-on, MAC, or Matco soft handle screwdrivers. I am not looking for any particular color, but not looking for a "fad" color that only raises the price.

Looks like I will take seconds on the spinflex if it falls through.

Dibs on Mac hard handle 3/8 Proto Spinflex Needle files PM Sent

Pull the deed to the property. It will state something like "from a pin located ***** follow a north, south, etc bearing for x number of feet to another pin". You should be able to see the markers off of those directions. I always try to go back 3 sales on the deeds, you may find a survey of...

PM sent on scraper and panel tool.

You know, the most important thing that you have said on here was overlooked. You spent time with your son sorting through your haul, and that is priceless.

I think that one of the key factors is going to be how much stress will be put on the part after the repair.

Ahh, most of us can only dream of luxuries like this. I would be spitting out all kinds of parts with this.