Recent content by nstei24

I went and removed the copper line and the unloader valve looked pretty good, but I went ahead and cleaned it up anyway. I figured I would keep going since I had it that far apart and started to drain the oil so that I could remove the crank cover and check out the unloader inside the crank...

Thank you all for the suggestions. I went out and tightened the belts more, and took the air filter off completely(it is some sort of fabric?) without any change in results. The motor also doesn't seem to slow down any.:headscrat There must be a little leak somewhere because it was up around 20...

Hello, I am having issues with my compressor building pressure. It builds up to 20PSI and continues to run, but does not build. Earlier this fall I used it to fill my Tubliss system on my dirt bike to 100PSI, but didn't run it for several months after. I started it up to use it a few weeks ago...