Recent content by Nthill93

Get some poly pipe pinch clamps like in post 35 and the tool.

Yeah lack of power I’ve done it with my m12 stubby and 3/8 m18 stubby and they’ve replaced both of them. Or you can test it yourself torque a bolt to 250 and see if it’ll take it off I have pretty much every m12 battery I just grab whatever is closest and charged. How much are we talking? I...

I have the 1/2” version and it keeps up with the m12 stubby impact. I think they’re about the same in terms of ft/lbs. is it still under warranty? I’d send it back. I never really see a difference in hitting power with different batteries.

Unless it’s a screaming deal I’d go buy a new one. I’ve got a graco project painter that I’ve painted a house with tons of trim and doors. If they’re not cleaning really well they take some work to get running again.

$3.09 on Long Island

If nat gas is on your block they’ll run 100’ of main and 100’ of service for free. If you’re not within those then you have to pay the extra distance

There should be case drain filters under the cab on the return lines from the drive motors. I’d pull those and see if they’re plugged with debris. There should also be one under the hydraulic tank where the return line goes into the tank

Is the parking brake stuck on? No noise when you lift the arms or tilt the bucket? If the brake is off jack up all 4 wheels and go forward reverse left right and try to bleed the air out. Open the hydraulic tank cap and see how much pressure is in the tank when it’s running. Should just be the...

Holy **** 1600 gals this winter? How big is your house? No nat gas in your area? I’m on LI too and I used like 600-700 gals a year before I swapped to gas and this was a very mild winter.

Broke a 1 1/4” 3/4 drive socket. Sent them a picture and new one came in the mail a few days later

$5/gal on Long Island. Thank god I went to gas this year. First bill was $70.

Simpson makes insulation support rods. I got them at Home Depot kind of pricey though

Redwing 2240’s

I tried acetone and compressed air last time and had to toss that gun. It looked pretty clean but the ball was all gummed up. It’s been like this for atleast 6 months never came in stock

I cannot find any spray foam gun cleaner in stock for the past couple months. Home Depot lowes ace Walmart Amazon all OOS by me. Any idea what’s going on? Is it just NY? I finally found some on Amazon but it’s $14 a can and a brand I’ve never used. Any other ways to clean out spray foam guns?