Recent content by off2aruba

before and after:

If some enterprising lad nabs that for parts, I need some.... put me on the list.

Thanks CRTDI, The first thing I know I need is the trigger for the handle position release. (Is the trigger for the 3 position handle release?) I think I could make a new one if some kind gentleman would take detailed pictures of one and post them......... And does the raise/lower nob look...

I picked this blackhawk S4 up today. It works, meaning the handle makes the lift pad go up and down, but it needs some TLC to put it back the way it should be. Going to need some parts.... would anyone have a parts diagram or source? (Hiball?)

So I picked up this little Torco, not in perfect shape, but it works. Do any of you VISE guys know what the two bolts sticking out of the dynamic jaw are for? holding in the main screw? I have tried to loosen / tighten them, but they will just spin. I have looked at some of the old...

40's era Snap-on. It was free. PO had it in their front yard collecting rain water. It was / is beat up real bad. One of the drawer slides was bent to the point the drawer wouldn't open all the way. The locking hasp has been replaced, looks like it was brazed (goldish looking weld )...

yabadoannaaafdasdf