Recent content by Ok Garage

So I got a RTI air dryer/filter from ebay and a norgren regulator. I'll start with this and see how it goes. Thanks for the help and suggestions. Ron

I am trying to stay right around $200 for regulator/filter.

Would you mind sharing what mfg/model? That's where I am having trouble on too put the pieces together.

I need some recommendations. I just replaced my 5hp air compressor with an Ingersoll Rand Type-30 Air Compressor 7.5 HP; 24 cfm @ 90 psig. My current Divilbiss filter does not meet the cmf requirement. I am looking at IR regulators/filters trying to put together a package that will work. I...

I had the same issue on trying to get a jack repaired. I ended up Frank at theserviceco.net do the rebuild. I first called and talked to him for a bit be comfortable that he was legit. He did everything he said that he would do and that was about 3 years ago. I know opinions may vary but I...

I needed a new bench grinder but didn't want a Chinese piece of junk and all of the new grinders appeared to be from China; exception being industrial models. I happened on this forum while searching for what would be a good used grinder and found the Craftsman Block Grinder posts. I found...

Never mind. I posted too quickly. It appears to be a left wheel problem...

I am stumped. I picked up a 19340 that ran when I went to look at it. I got it home, plugged in the power chord and it doesn't turn. You can only moved the wheel approximate 1/4". It's like there is a lock engaged that won't allow the wheels to rotate. I have pulled the side shields off to...