Recent content by OldSkool

Manual J for sure otherwise you would just be guessing. Size your ductless for heat load as opposed to cooling load. It's a heat pump with no supplemental to back it up in heating mode. Look for a system that will give full heating capacity at 0 to 5 degrees. Mitsubishi has a "Hyperheat" line...

Ah ****!!! You threw it away? I'm still holding out for parts for mine. My cylinder is still good. I could of used a couple of parts from your old one. Oh Man! So close yet so far away. I'm still looking for one to raid a couple of parts from.

More pics on the Sears jack Just a follow up to previous post

Hey Hiball. Here are some shots of dimensions of release gear. I PM'd you too with dimensions also. As far as the welded gear goes, check "bejasud's" recent post to you about a grinder damaged piston. His second pic shows the exact setup I have. As a matter of fact, his jack appears to be...

Yup. Waiting on Hiball to contact his source as he mentioned in his reply to my post concerning o-ring seal in my unit yesterday. Thought I would get a jump on things. Thanks

Shot in the dark here. One tooth gone and another ready to go. Others showing some cracking. If any one has a junk sears jack they'd be willing to part out, I could use this assembly. Blackhawk carries a gear but it's a bolt on. Mine as you can see is welded. I would grind the weld away and roll...

I just want to thank you for taking the time to answer my post. Just read your post on import jack breakdown and it was very helpful. I have some direction now. I hope in the future I'll be able to contribute here to help yourself or someone else to return the favor

Hello Hiball. Thanks for the warm welcome. There is a good possibility my unit uses just the balls. I ran the fluid (along with used motor oil that was already in my waste bucket) through a screen when I searched for the balls. Didn't turn anything up accept the balls. I'm guessing that if the...

Cruising the internet and found this place or should I say an old thread on the subject of the "green" Sears jacks. I've had this jack for 35+ years and don't want to have to trash it. (sentimental reasons). It was originally given to my Father as a Xmas gift and I inherited it. Very robust and...